Description

Each bearing has a built-in isolation switch shaft assembly, the assembly between the two axes by connecting plates, screws and other connecting the drive to adjust.

Refers to the middle portion of the contact pairs of the contact assembly, using self-elastic contact finger in the form of roll-in, in order to reduce opening and closing the contacts and the contact fingers of wear and improve life.

Disconnectors with earthing switch, fan-shaped plate leading electrical circuit and grounding switch and interlock with the base of the curved panels that switch on when leading electrical circuit, grounding switch is not closing, when the grounding switch is closed, the leading electrical circuit can not be closed. Chain plate chain disconnectors and earthing switches on the realization by the agency when equipped with CS8-6D.

Features

Isolating switch with double column, contact into open type structure, has the ability of self-cleaning contact, improve the contact reliability;

Finger made of new material with high strength, high conductivity, high elastic. Relying on the elastic contact finger clamping itself, to avoid the spring corrosion, contact clamping fever caused by annealing

Force to reduce the contact resistance increases, the contact heat intensified the vicious spiral

The rotating part according to the design requirements of the isolating switch maintenance free. The rotating seat designed seal structure, moisture, dust and harmful gas can not enter, bearing, molybdenum disulfide lithium base grease will never work in

A good environment, bearing, never rust, grease can not be lost, never dry up, the isolation switch operating torque will increase after long term operation. Stainless steel shaft and oil-free self-lubricating bearing

With the structure of steel by hot dip galvanizing, ensure the isolation switch operation is flexible, portable and reliable, never rust.

Normal Service Conditions

1. Altitude: 1000-2000mb.
2. Ambient temperature: no more than 40℃ and no less than-30℃ (no less than-40℃ in alpine areas)
3. Wind pressure: ≤700Pa (equaling wind velocity of 34m/s)
4. Earthquake intensity: ≤8
5. Ice thickness: ≤10mm
6. The installation location shall be free from flammability. explosive dangerous articles,chemical corrosion and fierce vibration
7. The pollution grade of post insulator: 0 for general type and II for pollution resistance type

Technical Parameters